Shrimp Feeding Tube with Dish for Rimless Tanks
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Feeding tube that hangs on the glass and drops food into a dish just above the substrate.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 0
- Makes
- 0
- Views
- 17
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Standard Digital File License
A square feeding tube that hangs on the glass and ends in a small dish 5 mm above the substrate, so sinking food lands in the dish instead of the gravel.
Drop food down the tube and it lands in a dish just above the substrate, where shrimp and snails can reach it and leftovers are easy to take out. The tube hangs on the top edge of the glass by a clip; the inside is 12 mm square, wide enough for 5 mm food. It prints lying on its side with no supports.
What it fits
Rimless glass 4, 6 or 8 mm thick (bare top edge; no plastic frame).
Drop from the top of the glass to the substrate: 150, 200 or 250 mm (one file each).
The clip's outer leg runs 12 mm down the outside of the glass: that strip must be bare glass.
What you need
PETG filament.
Print settings
Material: PETG
Nozzle: 0.4 mm
Layer height: 0.2 mm
Walls: enough to fill the walls
Infill: 100% — air sealed inside can make it lighter than water, and it only rests on the glass by its weight
Supports: None (the far side wall bridges 26 mm; leave bridge detection on)
Orientation: On its side, as in the file.
Bed: 150 and 200 mm drops fit 220 mm beds; the 250 mm drop (248 mm long) needs a 256 mm bed. On a 180 mm bed the 150 mm drop fits on the diagonal.
Files
shrimp-feeding-tube_drop{150|200|250}_glass{4|6|8}mm.stl— nine files: pick your drop and your glass
Fitting
Measure from the top edge of the glass down to the substrate where the tube will hang; pick the nearest drop below it.
Slide the clip over the glass edge; it should go on with a light push and sit flat.
Limits
A lid resting on the glass will sit on the 3 mm plate of the clip.
Food that sticks to the walls stays there; a knock can lift the dish.
How it was checked
Checked by simulation, not printed by us yet: the geometry is checked for fit (clearances), wall thickness against a 0.4 mm nozzle, bed size and overhangs. Loads are not simulated. If it does not fit, a comment with your measurements helps.
Safety
Use PETG for parts that stay under water.
A parametric version of this part is on mislastudio.com: https://mislastudio.com/m/tubo_alimentador?utm_source=printables&utm_medium=free_model&utm_campaign=tubo-alimentador
Designed by Misla, a small studio of engineered 3D-printable parts: https://mislastudio.com/?utm_source=printables&utm_medium=free_model&utm_campaign=tubo-alimentador