1 / 4
Airline Tubing Holder for Aquarium Glass — zdjęcie 1
1 / 4

Airline Tubing Holder for Aquarium Glass

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Slides over the glass edge and holds 1 to 3 airlines (6 mm OD) in upright push-in channels.

Ocena
0 / 5
Polubienia
2
Pobrania
3
Wydruki
0
Wyświetlenia
17
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Pets
Licencja
Standard Digital File License

A clip that slides over the top edge of the glass and holds one to three airlines upright in push-in channels on the inside of the tank.

Airline tubing that hangs loose drifts across the glass. This holder slides over the top edge and each line pushes in through a 4.5 mm mouth into a 6.4 mm round channel: the channel guides the tubing without squeezing it. It hangs 25 mm down the inside of the glass and prints upside down with no supports.

What it fits

  • Airline tubing with a 6 mm outside diameter (the common 4/6 mm size).

  • Rimless glass 4, 6, 8 or 10 mm thick.

  • One, two or three channels.

What you need

  • PETG filament.

Print settings

  • Material: PETG

  • Nozzle: 0.4 mm

  • Layer height: 0.2 mm

  • Walls: 3

  • Infill: any

  • Supports: None

  • Orientation: Upside down, as in the file (the plate that sits on the glass goes on the bed).

  • Bed: Tiny: 12–29 × 20–26 × 28 mm. Any bed.

Files

  • airline-holder_glass{4|6|8|10}mm_{1|2|3}tube.stl — twelve files: pick your glass and how many lines

Fitting

  • Slide the holder over the glass edge by hand: it should go on with a light push.

  • Push each airline in through the opening at the front of its channel.

Limits

  • Drawn for a bare, square-edged glass; a plastic frame with a lip may get in the way.

  • How firmly it grips the glass is not calculated.

How it was checked

Checked by simulation, not printed by us yet: the geometry is checked for fit (clearances), wall thickness against a 0.4 mm nozzle, bed size and overhangs. Loads are not simulated. If it does not fit, a comment with your measurements helps.

Safety

  • Use PETG for parts that sit in the water.

A parametric version of this part is on mislastudio.com: https://mislastudio.com/m/suporte_mangueira_ar?utm_source=printables&utm_medium=free_model&utm_campaign=suporte-mangueira-ar

Designed by Misla, a small studio of engineered 3D-printable parts: https://mislastudio.com/?utm_source=printables&utm_medium=free_model&utm_campaign=suporte-mangueira-ar

Tagi