1 / 4
Airline Tubing Holder for Aquarium Glass — image 1
1 / 4

Airline Tubing Holder for Aquarium Glass

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Slides over the glass edge and holds 1 to 3 airlines (6 mm OD) in upright push-in channels.

Rating
0 / 5
Likes
2
Downloads
3
Makes
0
Views
21
Reviews
0

Updated at source:

Model information

Category
Pets
License
Standard Digital File License

A clip that slides over the top edge of the glass and holds one to three airlines upright in push-in channels on the inside of the tank.

Airline tubing that hangs loose drifts across the glass. This holder slides over the top edge and each line pushes in through a 4.5 mm mouth into a 6.4 mm round channel: the channel guides the tubing without squeezing it. It hangs 25 mm down the inside of the glass and prints upside down with no supports.

What it fits

  • Airline tubing with a 6 mm outside diameter (the common 4/6 mm size).

  • Rimless glass 4, 6, 8 or 10 mm thick.

  • One, two or three channels.

What you need

  • PETG filament.

Print settings

  • Material: PETG

  • Nozzle: 0.4 mm

  • Layer height: 0.2 mm

  • Walls: 3

  • Infill: any

  • Supports: None

  • Orientation: Upside down, as in the file (the plate that sits on the glass goes on the bed).

  • Bed: Tiny: 12–29 × 20–26 × 28 mm. Any bed.

Files

  • airline-holder_glass{4|6|8|10}mm_{1|2|3}tube.stl — twelve files: pick your glass and how many lines

Fitting

  • Slide the holder over the glass edge by hand: it should go on with a light push.

  • Push each airline in through the opening at the front of its channel.

Limits

  • Drawn for a bare, square-edged glass; a plastic frame with a lip may get in the way.

  • How firmly it grips the glass is not calculated.

How it was checked

Checked by simulation, not printed by us yet: the geometry is checked for fit (clearances), wall thickness against a 0.4 mm nozzle, bed size and overhangs. Loads are not simulated. If it does not fit, a comment with your measurements helps.

Safety

  • Use PETG for parts that sit in the water.

A parametric version of this part is on mislastudio.com: https://mislastudio.com/m/suporte_mangueira_ar?utm_source=printables&utm_medium=free_model&utm_campaign=suporte-mangueira-ar

Designed by Misla, a small studio of engineered 3D-printable parts: https://mislastudio.com/?utm_source=printables&utm_medium=free_model&utm_campaign=suporte-mangueira-ar

Tags