USW-Flex-2.5G-8- PoE 19-inch locking Modular Rack Mount mit Blende
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix: USW-Flex-2.5G-8-PoE 19-inch Modular Rack Mount that uses the Ubiquiti included wall mount to lock the switch in
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 55
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Remix of the original USW-Flex-2.5G-8-PoE 19-inch Modular Rack Mount
with an extended lower-front bar. This allows you to use the original wall-
mount included in the box with the switch to lock it in the rack and prevent
it from sliding forward when cables are pulled. With a stiff enough filament
and tight tolerances it can even hold it face down. For typical horizontal
rack mounting it should work with just about any rigid filament.
That said, if the filament you use does flex a bit too much, if the tolerances
just aren't there on your print, if you're mounting in an unconventional
orientation, or if you just want that little extra security I also included an
optional locker plate. To use the locker plate, screw the original wall-mount
to the lock plate. It will essentially just make your wall mount 2mm thicker
such that tolerance or flex shouldn't be an issue.
If you are using the locking plate you will need 2 M3x6mm countersunk
screws in addition to the M5 screws/nuts recommended by the original print.
Note: the locking plate is NOT symmetrical since it's designed to be
centered when installed and the original wall-mount is offset when it locks in.
Check out the pictures to see how it works!