QIDI X-Max 3 – Top Cover Corner Holders
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
QIDI X-Max 3 – Top Cover Holders for Open-Top Printing
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Want to print with your QIDI X-Max 3 with the top cover removed, but don't want to leave the cover lying around on your workbench?
These custom-designed corner holders provide a simple and practical solution. They replace the original top cover mounting points and allow you to store the original cover neatly in four dedicated grooves while keeping the top of the printer open.
The original cover fits securely into the grooves and holds all four holders in place. No glue, screws or additional fasteners are required.
This modification is particularly useful when printing PLA or PETG, when an open-top configuration may be preferable depending on the filament and printing conditions.
Features
Designed specifically for the QIDI X-Max 3
Reuses the original top cover
Four corner holders with fitted grooves
The original cover keeps the holders securely in position
No glue, screws or additional fasteners required
No drilling, cutting or other modifications needed
Fully reversible modification – restore the original configuration at any time
Keeps the removed cover neatly stored above the printer
Prints without supports
Required parts
4× printed corner holders
1× original QIDI X-Max 3 top cover
Recommended print settings
Material: PETG or PLA
Layer height: 0.20 mm
Perimeters / walls: 3
Top layers: 4–5
Bottom layers: 4–5
Infill: 20–25%
Supports: Not required
These are recommended starting settings, not verified records of the original print profile.
Installation
Remove the original top cover.
Install one printed holder at each of the four original cover mounting points.
Insert the original cover into the grooves of the holders.
Check that all four corners are seated correctly and that the cover holds the holders securely in place.
That's it! No glue, tools or permanent modifications required.
Notes
Both PLA and PETG can be used. Choose the material according to the operating temperature and conditions in which the holders will be used. Avoid exposing PLA holders to excessive heat.
Designed and tested on the QIDI X-Max 3.