Hultarp Magnetic Rack Mount for Skadis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount IKEA's magnetic Hultarp knife rack to the Skadis pegboard. No extra hardware needed.
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 95
- Wydruki
- 2
- Wyświetlenia
- 1345
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Mount IKEA's magnetic Hultarp knife rack to the Skadis pegboard.
No extra hardware needed, just a flat head screwdriver to twist in the pins.
Print one of each pin. The orientation of each corresponds to the holes in the Hultarp's bracket.
The mid-support is optional but recommended. It keeps the bracket in place and also takes some of the weight off the pins, especially when held to the bracket with double-sided adhesive tape.
For best results:
- Use a layer height of 0.12mm or lower on all pieces.
- Print the pins with 100% concentric infill or increase the number of perimeters/walls. The mid-support can be printed with minimal infill.
- Use supports on all pieces. Ensure all support material is fully removed and cleaned up.
- Apply forward pressure when twisting the pins in place to avoid snapping.
- Use a filament with a bit off flex, like PETG. PLA works fine but can snap.
Note: The holes in the Hultarp bracket line up perfectly with the Skadis, so you could also attach it with some M4 bolts and washers. The mid-support would still be useful in this case.