1 / 2
LOSI 5IVE-T 3.0 BOLT-ON FRONT GRILLE — zdjęcie 1
1 / 2

LOSI 5IVE-T 3.0 BOLT-ON FRONT GRILLE

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Printable front grilles for the Losi 5IVE-T.

Ocena
0 / 5
Polubienia
2
Pobrania
6
Wydruki
0
Wyświetlenia
34
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

Installation video: https://www.youtube.com/watch?v=AK8eCsPLm8o

To Install you will need:
Drill w/ M2.5 or smaller drill bit
Dremel with cutting wheel and abrasive wheel
6x M2-2.5 Button Head Screws (M2.5 screws will be a tight fit)
6x M2-2.5 Hex Nut
12x Washers

Center and line up the strong template against the lower lip for drilling and lining up the holes. Then install the regular template and use a cutting wheel on the Dremel to roughly cut out the grille area. Finish with the abrasive wheel, being careful to not remove too much material. Then Install with the listed hardware.

I did not produce any of the logos. Many models were used to make these, thank you to all who provided free models to remix.

Tagi