ZX4R Customizable Thigh Grips.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
thigh grips for zx4r
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 94
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
INTRO:
This is the second addition to the knee grip fairings project, which can be found here.
This one is intended to add some grip to your thigh area. The model was created by:
Creating a faceset on the original fairing by using normal view automasking and the lasso faceset tools.
The faceset was then extracted and cleaned up a little. Make sure to delete the default Solidify modifier.
The mesh was then manifold extruded by 0.8mm.
You can easily make your own custom one with a different profile if you want by following the following steps in about 20 minutes.
Making A Custom Grip Texture:
To make a custom knee grip, download the blank and go to bumpmesh.com .
Upload the model to the website. You can also run the program locally from GitHub.
Orient the model upright by rotating it or placing it on a desired face as shown below.
Select the texture pattern that you like,
Adjust the texture smoothing to your preference; invert for knurling texture or if you just want to.
Set texture height/thickness to 5 mm. For whatever reason, the output model is approximately displaced by half of the set value (so an input of 5 will only displace the mesh by 2.5mm in this case). I have no idea why this happens. You will have to mess around with this value to get your desired results.
UV scaling to adjust the size (I prefer 15-25 for most textures).
Set masking to "Include" only and "Fill".
Set the masking max angle to 20° and then click on the middle of the grip area.
Refine the edges using the brush to add and remove extra selection if needed. The next step will smooth out the results from this step, so don't be too worried about the mask edges if they look a little rough.
Smooth mask distance to 2 mm. Set to linear.
Export the final model (0.2- 0.3 mm resolution recommended)(1-1.5 million polygons).
Print the grip texture preferably in TPU. The model should only be 0.8mm thicker than the stock setup. You could also use 3M 468MP Adhesive Sheets, provided you clean the surface well
I have not printed the models yet as I am out of TPU for the moment, so please do let me know how the fitment is
You can find my other zx4r 3d scans all FOR FREE on my printables page.