1 / 5
DA-K6402W 2.5GbE Switch 1U Rackmount for 10" and 19" Racks — zdjęcie 1
1 / 5

DA-K6402W 2.5GbE Switch 1U Rackmount for 10" and 19" Racks

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This model includes STEP files to print a rack mount for the small unmanaged 2.5GbE Switch (sometimes called: DA-K6402W)

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
12
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This model is about providing a printable 1U rack mount for the small unmanaged 2.5GbE Switch (sometimes called: DA-K6402W but can also have various other names).

The switch measures: 133mm in Width, 67mm in Depth and 33mm in Height

This project includes a main enclosure where the switch can slide in from the back and is held in place by lips/clips on the back side (be careful when inserting the switch as not to break them off like I did).

Then there are 3 types of brackets that go on each side. One for my custom 340mm wide Bosgame M5 rack (Screwed in via M5x8mm screws), one for 10" Serverracks and one for 19" Serverracks. The brackets are screwed into the plastic of the switch enclosure via 6x M3x16mm screws (12mm also possible, ISO4762 recommended).

Print recommendations:

  • Material: PLA, PETG or ABS (depending on how warm your switch gets)

    • Avoid super brittle materials for the clips

  • Orientation: Face/Front down

The project incudes the FreeCAD project file alongside the STEP files.

The design is inspired by PileOPaul's Switch Rack Mount design:

https://www.printables.com/model/1276621-mokerlink-2g080110gsm-10-inch-rack-mount

Tagi