Whetstone Storage Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Whestone box (like. Chosera, Naniwa, Sharpton. etc)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
I created this 3D model to store my Naniwa Chosera, Shapton Kuroaku, Shapton Rockstar, and Atoma Diamond Whetstone.
I printed it using Prusament Army Green PLA, but unfortunately, I ran out of filament near the end, so approximately the top 15% of the model was left unprinted. ;(
However, the printed model works great, and I'm using it regularly. I printed it with 45% gyroid infill, which provides more than enough strength. I think the infill density could be reduced even further.
I use it on the wire rack over my kitchen sink. However, if you plan to use it on a solid surface where water cannot drain away, I recommend printing a few 10 × 10 mm cubes and attaching them to the bottom with super glue to raise it slightly and allow water to drain underneath.