Whetstone Storage Box
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Whestone box (like. Chosera, Naniwa, Sharpton. etc)
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 9
- Makes
- 0
- Views
- 46
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
I created this 3D model to store my Naniwa Chosera, Shapton Kuroaku, Shapton Rockstar, and Atoma Diamond Whetstone.
I printed it using Prusament Army Green PLA, but unfortunately, I ran out of filament near the end, so approximately the top 15% of the model was left unprinted. ;(
However, the printed model works great, and I'm using it regularly. I printed it with 45% gyroid infill, which provides more than enough strength. I think the infill density could be reduced even further.
I use it on the wire rack over my kitchen sink. However, if you plan to use it on a solid surface where water cannot drain away, I recommend printing a few 10 × 10 mm cubes and attaching them to the bottom with super glue to raise it slightly and allow water to drain underneath.