Wall-Mount Poop Bag Dispenser (Stacks 35mm Rolls)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall-mounted, gravity-fed poop bag dispenser that stacks 35 mm bag rolls. No supports needed.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A wall-mounted dispenser for dog poop bag rolls. Drop a stack of rolls in the top, pull a bag from the slot at the bottom, and tear it off on the built-in bar. Mount it by the door or on a post next to where you leash up, so you never leave without bags.
Remix notes
This is a remix of Dog Poop Bags Roll Dispenser by MeetYourMaker. The original fits rolls about 30 mm in diameter and 61 mm long. I made it bigger to fit Earth Rated Dog Poop Bags on Refill Rolls (Unscented, 600-bag pack).
What bags fit
Rolls up to 35 mm in diameter and about 60 mm long
Tested with Earth Rated refill rolls (600 bags, unscented)
Features
Gravity feed: the next roll drops down when one runs out
Front windows show how many rolls are left
Tear bar at the bottom outlet
Two keyhole slots on the back for screw mounting
Prints upright with no supports
Print settings
Included in the print profile.
Filament: PETG (holds up outdoors better than PLA)
Layer height: 0.2 mm
Infill: 15%, 2 walls
Supports: none
Size: about 71 x 90 x 187 mm
Mounting
Use two small pan-head or round-head screws (with wall anchors in drywall or masonry).
Leave the screw heads a few mm proud of the surface, then hang the dispenser on the keyholes and slide it down.
Load the rolls and feed the end of the bottom roll out through the slot.
Remix credits
Earth Rated Dog Poop Bags Roll Dispenser - Wall Mounted by With_Maltodextrin (Printables)
Dog Poop Bags Roll Dispenser by MeetYourMaker (MakerWorld), the model this is directly remixed from
Print profile
0.2mm layer, 2 walls, 15% infill
X1 Carbon, 0.4 mm nozzle, PETG. 0.2 mm layers, 2 walls, 15% infill, no supports. Prints upright in one piece. Fits Earth Rated refill rolls (about 35 mm across).
Sliced for: Bambu Lab X1 Carbon
Plates: 1
Print time: about 4 h 18 min
Filament: PETG #161616 (140 g)
File: the 3MF labeled "print profile" in Model Files
Also on MakerWorld, with one-click print profiles for Bambu Studio: Wall-Mount Poop Bag Dispenser (Stacks 35mm Rolls)