1 / 5
Wall-Mount Poop Bag Dispenser (Stacks 35mm Rolls) — image 1
1 / 5

Wall-Mount Poop Bag Dispenser (Stacks 35mm Rolls)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A wall-mounted, gravity-fed poop bag dispenser that stacks 35 mm bag rolls. No supports needed.

Rating
0 / 5
Likes
0
Downloads
3
Makes
0
Views
26
Reviews
0

Updated at source:

Model information

Category
Pets
License
Creative Commons — Attribution — Noncommercial — Share Alike

A wall-mounted dispenser for dog poop bag rolls. Drop a stack of rolls in the top, pull a bag from the slot at the bottom, and tear it off on the built-in bar. Mount it by the door or on a post next to where you leash up, so you never leave without bags.

Remix notes

This is a remix of Dog Poop Bags Roll Dispenser by MeetYourMaker. The original fits rolls about 30 mm in diameter and 61 mm long. I made it bigger to fit Earth Rated Dog Poop Bags on Refill Rolls (Unscented, 600-bag pack).

What bags fit

Features

  • Gravity feed: the next roll drops down when one runs out

  • Front windows show how many rolls are left

  • Tear bar at the bottom outlet

  • Two keyhole slots on the back for screw mounting

  • Prints upright with no supports

Print settings

Included in the print profile.

  • Filament: PETG (holds up outdoors better than PLA)

  • Layer height: 0.2 mm

  • Infill: 15%, 2 walls

  • Supports: none

  • Size: about 71 x 90 x 187 mm

Mounting

  1. Use two small pan-head or round-head screws (with wall anchors in drywall or masonry).

  2. Leave the screw heads a few mm proud of the surface, then hang the dispenser on the keyholes and slide it down.

  3. Load the rolls and feed the end of the bottom roll out through the slot.

Remix credits

Print profile

0.2mm layer, 2 walls, 15% infill

X1 Carbon, 0.4 mm nozzle, PETG. 0.2 mm layers, 2 walls, 15% infill, no supports. Prints upright in one piece. Fits Earth Rated refill rolls (about 35 mm across).

  • Sliced for: Bambu Lab X1 Carbon

  • Plates: 1

  • Print time: about 4 h 18 min

  • Filament: PETG #161616 (140 g)

  • File: the 3MF labeled "print profile" in Model Files

Also on MakerWorld, with one-click print profiles for Bambu Studio: Wall-Mount Poop Bag Dispenser (Stacks 35mm Rolls)

Tags