1 / 2
Weatherproof Power Strip Box (Schuko 3-Way, Snap-Fit) — zdjęcie 1
1 / 2

Weatherproof Power Strip Box (Schuko 3-Way, Snap-Fit)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Splash-proof PETG case for a 3-way Schuko power strip. Snap-on lid, tongue-and-groove seal, TPU cable grommets. No screw

Ocena
0 / 5
Polubienia
3
Pobrania
3
Wydruki
0
Wyświetlenia
46
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

A splash-proof enclosure for using a power strip outdoors, in the garden, on the balcony or in a workshop. Inspired by the popular store-bought cable boxes, but printable and sized for your strip.

Fits

  • Power strip up to 175 × 45 × 40 mm (3 Schuko sockets with switch)

  • Power cord strain relief up to about 2.5 cm long

  • Plugs up to about 25 mm tall above the strip, including 45° angled plugs

  • Cables 6–8 mm thick (other sizes via the script)

Features

  • Snap-fit lid with 8 flexible hooks, no tools and no screws

  • Tongue-and-groove seal around the whole rim

  • 6 cable holes split at the joint, so you can fit cables with the plug already attached: 5 on the front, 1 at the switch end

  • TPU grommets for 7.0 mm, 6.8 mm and 7.8 mm cables, plus a blank plug for unused holes (print it 3×)

  • Ribs keep the strip off the floor, with notches so water can’t collect

  • 3 mounting tabs for screwing it to a wall or board

  • Prints without supports

Size

  • Outside: 261 × 108 × 78 mm

  • Inside: 255 × 102 × 72 mm

  • Needs a print bed of at least 270 × 135 mm. A split version for 180 mm beds is on request.

Customize (advanced, provided as-is)
make_box.py generates the case and grommets from your own measurements.

  • Needs Python 3 with manifold3d, trimesh and numpy (pip install manifold3d trimesh numpy)

  • Change the values at the top of the script, then run: python make_box.py

  • strip_len, strip_w, strip_h: size of the power strip body in mm

  • plug_height: how far the plugs stick up above the strip

  • socket_pos: socket centres, measured from the end without the switch

  • end_room_cable: room at the switch end (strain relief length + about 15 mm)

  • cables: your cable diameters, e.g. [7.0, 6.8, 7.8]. One grommet is made per cable.

  • extra_front_holes: number of spare holes on the front (default 2)

  • split: False for the one-piece version, True to split it for beds of about 180 mm

  • The STL files are saved next to the script

Tagi