GoPro Attachment for Canyon Stem Computer Mount Garmin & Wahoo (Canyon Grizl CF 8 Di2 and similar bikes)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Realized your Canyon Stem Mount lacks an underside GoPro mount? Fix it with this model and 3M VHB tape!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 60
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
I designed this because I bought a Canyon Stem Computer mount without thinking much and realized it too late. Canyon's return policy states that if the return value is below 40€, the customer pays for the return - which means pragmatically it's better to tinker and use what I bought. That's the back story!
While similar GoPro mount attachments are available in the market, I created this model to ensure using every possible square millimeter under the computer mount for adhesion while causing minimal damage to the product.
Highlights
Compatible with the computer mount for Canyon ST35/ST37/ST46 stems. See the product page for full compatibility details: https://www.canyon.com/en-nl/gear/accessories/cockpit-and-handlebar-mounts/canyon-stem-computer-mount/10013811.html
Use PETG (or a better material) to print the model. Optional parts and disposable tools can be printed with PLA.
Use a strong adhesive such as 3M VHB 5952 tape.
My Slicer Settings
For the main model:
Wall line count: 6
Infill: gyroid 60% (perhaps it doesn't matter)
Top/bottom layers: 6
Tilted print orientation (see photos)
Ensure that the Z-axis seam doesn't end up on the flat surface
Using a support blocker as shown saves approximately 1 g of PETG and 11 minutes of print time. ;)
For optional models/ disposable tools:
Standard PLA settings from the slicer.
How to use
Decide whether it's a Garmin or Wahoo, then print the corresponding model. Once it's in place, the bond is supposed to be permanent.
Sand the flat surface of the printed model.
Clean the PETG and Aluminium surfaces thoroughly (with 99.9% IPA).
Optional: If you intend to switch between Garmin/Wahoo by forcibly destroying the bond at a later time - you can proactively use the included hex socket covers to prevent the adhesive from ruining the tiny hex bolts.
Use 3M VHB 5952 tape or a suitable strong adhesive. Clamp if necessary. Refer to the instructions of the adhesive. (I used the following product and left it clamped for 72 hours: https://www.bol.com/nl/nl/p/10-stuks-3m-vhb-5952-dubbelzijdig-acryl-schuim-tape-vierkant-5x5cm-waterdicht-hittebestendig-zelfklevend-voor-hobby-decoratie-elektronica-auto-metaal-glas-kunststof-zwart/9300000254239673/)
Optional: Use the disposable clamping helpers to protect the computer mount and the printed part if you decided to use a high pressure clamp during adhesive curing.
Optional: You can also use zip ties or a lanyard as a safety harness in case the adhesive fails.
Note: Included hyperlinks are not affiliate links and I do not receive any incentives on those.