1 / 5
Netgear GS305v3 / GS305E LED Cover (both LEDs per port, tight fit) — zdjęcie 1
1 / 5

Netgear GS305v3 / GS305E LED Cover (both LEDs per port, tight fit)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix for GS305v3/GS305E: covers both LEDs of every port and the power LED, spring tabs for a snug fit.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
8
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

Remix of "NETGEAR GS305 LED Cover" by HDCry. The original blocks one LED per port. The newer GS305v3 / GS305E has an LED in both top corners of every jack, and its power LED sits higher and is larger, so it shines past the original tab.

Changes:

  • Tabs over BOTH LEDs of every port (left and right). Neighbouring tabs are joined for stiffness.

  • Everything left of port 1 and right of port 5 is closed, which also hides the power LED completely.

  • The logo slot is closed for a stiffer front plate. Instead there is a small notch above each jack, so the latch lever of the RJ45 plug has room.

  • Tighter fit: four spring tabs with small clamping bumps (two on top, one on each side). The bottom wall stays rigid, so the front stays aligned with the jacks.

  • To make room for the spring tabs, the cover is 11 mm deep instead of 9 mm.

Print settings:

  • PETG recommended (the spring tabs survive better than in PLA).

  • Front plate on the bed, no supports needed.

  • At least 2 walls/perimeters, so the 0.8 mm spring tabs are printed solid.

Printed in PETG and tested on the switch it was designed for: the cover sits firmly and hides all LEDs.

The OpenSCAD source is included. Parameters at the top: LED positions, tab sizes and bump height (nase_oben, nase_seite) if you want it tighter or looser.

Tagi