Snowmote 3 - Case for Pubmote / Pingumote

3d printed case for the Pubmote project, a VESC onewheel tilt remote.

Hardware Requirements

• Pingumote ESP32-S3 Display (Waiting for a proper product page)

• PS5 hall joystick or similar

• Battery

  •  1500mAh Lipo battery (this is the one the case is designed for, but others of similar dimensions or smaller will work)

  • 1.25mm JST connectors

• 2 x M3x5 screws

• 2 x M3xD5xL4 heat set inserts

• 4 x M2x8 screws

• 4 x M2 nuts

Printing Instructions

Print in your preferred material with as much infill as you like, but here are some print settings recommendations:

• 30%-50% infill, so the large, flat areas are sturdy

• Face down on the bed, so no supports are needed

• TPU lid

• PETG or other solid floor piece

Assembly Instructions

See GitHub repository for instructions (pending)