MagSafe pop socket and stand

Magnetic pop socket and stand for iphones with MagSafe (iPhone 12 or newer)

magsafe.stl

• This is main magnetic MagSafe attachment
• Magnets: 40 pcs of  4x1mm magnets (example on eBay I used)
• To embed magnets, add a “Add pause print (M601)" by right- clicking the [+] button at z-height shown in screenshot
• To orient the magnets, just check the poles by testing on your phone. All outer magnets have same polarity, and all inner magnets are the opposite.
  
   
• Correct height to pause print (Prusa Slic3r)
  
  
• 
  
   
• 
   

magsafe-less-snug.stl

Same as magsafe.stl but gives a bit more space for magnets. Use this if magsafe.stl comes out too tight on your printer.

socket.stl

The pop socket handle to screw onto main plate

stand.stl / stand-tall.stl
 

The phone stand to that holds the socket. The two versions are 100cm and 120cm high. 120cm. I prefer the smaller one, but the charging cable bends when phone is vertical.

car-mount.stl

Replaces socket.stl to mount the phone in car using a clamp style car phone mount