Magnetic Pry Bar Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic pry bar holder. I have Harbor Freight pry bars, but it should work with others.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 49
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I really liked the design of this pry bar holder, but I wanted it to magnetically attach to my toolbox instead of attaching to a wall.
The model uses 4 15x3mm magnets that are print-in-place so no glue is needed to insert the magnets. The magnets are also just far enough in that along with attaching magnetically, it also gives a slight pull on the pry bar to help hold it into place. To install the magnets, set PrusaSlicer to pause right before it prints the top layer above them. Also make sure that you alternate the poles on each magnet so they have a stronger hold. I have also provided a gcode file for a MK4S if needed. The magnets I used can be found at https://www.amazon.com/dp/B0FNX636SK, they hold quite well.
The print does not require any supports. I printed mine in PETG since it lives in my garage and I wanted the extra heat tolerance.