Insertion / Removal Tool for Prusa Spool Filament Storage MaxFlow4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small printable handle that makes it easier to put the MaxFlow4 part into the spool and to take it out.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Summary: A small printable handle that makes it easier to put the MaxFlow4 desiccant box into the spool and to take it out.
Description:
Fitting the Prusa Spool Filament Storage MaxFlow4 (the desiccant box) into the spool, or pulling it out again, can be hard. This tool gives you a comfortable grip so you can insert and remove it without struggling. The fluted outer edge helps your fingers hold on, even when it is tight.
Dimensions: about 57 × 57 × 50 mm.
Print orientation: fluted face down, flat on the bed (as in the STL). no supports are needed.
⚠ Infill: please read if you slice the STL yourself
The part is printed with 15 % gyroid infill, plus a reinforced zone at 25 % gyroid between Z = 5 mm and Z = 27 mm. This zone is there for mechanical reasons only: it strengthens the area where the tool and the MaxFlow4 part touch, so the four fins do not break when you tap on the tool to release the box. Please keep it if you want the tool to last.
The STL does not contain this setting, so you have to add it yourself (the 3MF already includes it).
In PrusaSlicer:
Right-click the part → Add modifier → Cylinder.
Set its size to 60 × 60 × 22 mm and place it so that it covers Z = 5 to 27 mm (centre at Z = 16 mm).
Right-click the modifier → Add settings → Infill, then set Fill density = 25 % and Fill pattern = Gyroid.
In another slicer, use the equivalent: 25 % gyroid infill for the height range 5–27 mm.
Print settings (as used for my prototype):
Printer: Original Prusa MK3S+ (0.4 mm nozzle)
Material: PLA (Prusament PLA, 215 °C nozzle / 60 °C bed)
Layer height: 0.20 mm (0.20mm QUALITY @MK3 profile)
Perimeters: 2 | Top / bottom layers: 5 / 4
Infill: 15 % gyroid, 25 % gyroid in the zone above
Supports: none | Brim: none
Orientation: fluted face down, flat on the bed
Print time: 2 h 48 min
Filament used: 10.28 m
Files: STL, plus a 3MF PrusaSlicer 2.9.6 project with all settings included.
Related: Designed to work with PRUSA Spool Filament Storage / MaxFlow⁴ by Professional3D.