Coralboard 10-inch 1U Rackmount Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A split 10-inch 1U Coralboard rackmount with a customizable side-panel.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 540
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
A two-part 10-inch 1U rackmount enclosure designed around the Coralboard reference model.
The nominal front panel is 254 mm wide and 44.45 mm high. It is split into left and right printable modules joined by an interlocking sliding dovetail. Two horizontal screws and captive nuts secure the centre joint.
The left module carries the board. The right module is available in six interchangeable versions:
Mounting openings for two RJ45 keystone connectors and two SMA bulkhead connectors
A blind panel without a base
A blind panel with a plain base for adapting other equipment
A carrier for a second Coralboard, with matching mounting points and front openings
Mounting openings for four keystone connectors
A blind panel with a slotted base for adjustable mounting or cable ties
The connector openings provide mechanical mounting space for separately purchased connectors. The blind panels have unmarked front faces.
The rack assembly has captive reset and user button pistons, labelled faces and a layout intended for a compact rack or lab installation.
The main plate contains all four parts:
Left rack module
Original right rack module
Reset button piston
User button piston
The alternative right modules are supplied separately. Use one right module per assembly. The second Coralboard version requires an additional reset button piston and user button piston.
Supports are required, and the small button pistons may benefit from a brim on some printers.
Nominal hardware shown in the standard configuration renders:
4x | M3 × 6 mm board screws
4x | heat-set inserts
2x | M3 × 12 mm joint screws
2x | M3 nuts
2x | RJ45 keystone connectors
2x | SMA bulkhead connectors
The second Coralboard version requires an additional four board screws and four heat-set inserts. Connector quantities depend on the right module selected.
Physical printing, assembly fit and rack hardware compatibility have not yet been tested.
Check out the desktop case version too: