1 / 4
Behringer P16-HQ / P16-M to Roland Drum Module Clamp Adapter — zdjęcie 1
1 / 4

Behringer P16-HQ / P16-M to Roland Drum Module Clamp Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount a Behringer P16-HQ or P16-M on your drum rack using a Roland-style module clamp.

Ocena
5 / 5
Polubienia
2
Pobrania
5
Wydruki
1
Wyświetlenia
14
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Noncommercial

This plate bolts to the back of a Behringer P16-HQ, using the same 3-hole pattern as the P16-M and Behringer's P16-MB bracket. On the other side is a solid 23 mm stub post that fits a Roland-style drum module clamp, so the P16 sits on the drum rack right next to your module.

Features

  • Tested: printed in PLA, bolted to a P16-HQ, and clamped on a PDS-5 stand.

  • Plate: 140 × 58 × 6 mm with rounded corners.

  • Stub: Ø23 mm, sticking out 74 mm past the plate (80 mm total depth), which leaves room to set the clamp height and angle.

  • A curved fillet where the stub meets the plate, for strength.

  • 4.3 mm clearance holes for M4 screws.

Hardware

  • 3 × M4×16 screws (the plate is 6 mm thick).

  • A Roland-style drum module clamp on your rack or stand.

Print settings

  • Orientation: plate flat on the bed, stub pointing up (as provided).

  • Supports: none.

  • Material: PLA (tested). PETG is fine too and copes better with heat and creep.

  • Layer height: 0.2 mm, 0.4 mm nozzle.

  • Walls: 6 (the stub carries the clamp load).

  • Infill: 15% crosshatch.

  • Brim: none needed.

  • Result: 46 g of PLA, about 1 h 42 m on a Bambu Lab P1P (0.20mm Standard profile).

Customise it

The parametric OpenSCAD source (p16_mount_plate.scad) is included. Change stub_height (overall depth; 40 gives a short stub), stub_d, plate_t or screw_clearance to suit your clamp and printer.

License

CC BY-NC 4.0. You're free to print, share and remix it with credit, but not to sell prints.

Thanks

Thanks to Patlach13, whose P16 mic-stand bracket on MakerWorld made it easy to check the P16's hole spacing. Look theirs up if you want a mic-stand mount instead.

Tagi