Prusa Core One + Gen2 Magnetic Top Cover (Remix for Gen2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic top cover for Prusa Core One + (remixed for Gen2)
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 12
- Wydruki
- 1
- Wyświetlenia
- 152
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of https://www.printables.com/model/1226383-prusa-core-one-magnetic-top-cover-with-integrated for Prusa Core One + (Gen2).
The differences are:
Removed front handle for sliding the vents, this is done done by internal automatic lever instead.
Instead use https://www.printables.com/model/1862226-longer-vent-opener-for-magnetic-top-cover for a longer vent opener to reach the new height as the lid is now further up.
Added more chamfers and fillets for sleeker design and better printability.
Added PETG plugs to fill the holes where the Gen2 opening levers were before.
Printing instructions:
Print "Frame Complete Set" in PETG. Note it is a multi-plate 3MF. I used orange for the two handles and black for the rest.
0.2mm layer height, structural, 15% infill. 0.4 mm nozzle. No supports needed.
Print the extended vent lever in a heat resistant material. I use Prusament PCCF (which is what the original part was also printed in). If you use a different material you may have to compensate for different shrinkage factor.
0.2mm layer height, structural, 15% infill. 0.4 mm nozzle. No supports needed.
Print the 4 plugs for the Core 1 + Gen2 levers in PETG or better. Not load bearing so default structural profile works fine.
Hardware needed:
Same as the original magnetic top cover:
8 5x5 round magnets
8 M3x10mm Button Head Cap or Socket Head Cap Screws. I used these: https://www.amazon.se/-/en/dp/B0FVT4NMVM
You will reuse the 4 screws for the Gen2 lid levers to mount the new blanking plates
Assembly instructions:
For the small covers that replaces the clips used in Core 1 + Gen2:
Remove the stock lever/clips, save the screw
Mount the blanking plates in the same manner as the original part (the tab sticking up through the rectangular hole, and secure using the screw from the previous step (gently as to not crack the panel).
For the vent lever, refer to the Original Prusa Core One + Gen2 assembly manual, but used the modified piece: https://help.prusa3d.com/guide/8-trim-door-xlcd_1117481#1133338
For the magnetic edge pieces, refer to the assembly instructions in the model this is a remix of: https://www.printables.com/model/1226383-prusa-core-one-magnetic-top-cover-with-integrated
CAD models in Onshape (better than STEP files, if you use OnShape):