1 / 3
Jet Airliner - Kit Card (2 Colours, Slot-Together, No Glue) — zdjęcie 1
1 / 3

Jet Airliner - Kit Card (2 Colours, Slot-Together, No Glue)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Snap-out kit card that slots together into a jet airliner. 2 colours, no AMS needed, no glue, no supports.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
13
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Building Toys
Licencja
Creative Commons — Attribution — Noncommercial

A 120 x 80 mm kit card, printed flat in one go. Snap the parts off the frame and slot them together into a jet airliner with swept wings, a T-tail, two engines and landing gear. No glue: everything joins with tight cross-lap slots.

FEATURES

  • Built size: about 88 x 72 x 28 mm

  • 2 colours: start in white, finish in blue

  • Prints flat with no supports, no AMS needed

  • About 11 g of filament

  • Part of a series of kit cards, collect them all

PRINT SETTINGS

  • The 3MF is ready to print: 0.2 mm layers, 7% gyroid infill, tree supports set to auto. The card prints flat, so no supports are actually generated

  • The parts are only 1.8 mm thick, so they come out almost solid

  • 2 colours: the 3MF has 2 parts, a white body and blue raised details, assigned to 2 filaments for AMS / multi-material printers

  • No AMS? Print the body in white, add a filament change at 1.8 mm, then finish in blue

  • Use a 0.4 mm nozzle

ASSEMBLY (raised side facing you)

  1. Snap the parts off the frame at the small gates, and trim any nubs.

  2. Press the fuselage tabs down into the slots in the middle of the wing.

  3. Slide the tailplane through the slot at the top of the fin.

  4. Press the two engines and the two main gear legs up into the slots under the wing.

  5. Push the nose gear up into the slot under the nose.

TIPS

  • The slots are a tight fit: 1.75 mm wide for 1.8 mm parts, with a small lead-in at each slot mouth. Push the parts together firmly and straight.

  • Too tight for your printer? Sand or file the slot once, or print the card at 99% in Z.

Tagi