1 / 7
ESHOOTER Flare Smoky BT: orange cap with swappable faces — zdjęcie 1
1 / 7

ESHOOTER Flare Smoky BT: orange cap with swappable faces

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Orange cap for the ESHOOTER Flare Smoky BT, with six swappable faces and editable OpenSCAD files.

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
36
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I needed an orange replacement for the black cap. The first print screwed on but had the wrong proportions. After correcting those and adding a grille, we split it into a threaded base and a removable face.

I tried the earlier six faces in orange PLA: good but not very tight fit, with LEDs and smoke working well. Rounded Crest was my favorite, so this revision adds a similar sloped shoulder to the other five. The five sloped faces printed well in orange PLA, and I’m happy with how they look. The base, Rounded Crest and attachment dimensions are unchanged.

Print

Print 00_Base_Ring.stl and one face: Rounded Crest, Three-Prong, Birdcage, Brake, Flow Cap or Killflash. Files are in millimeters, already oriented. Use 100% scale.

My print setup: K2 Pro, 0.4 mm nozzle, orange PLA, fixed 0.12 mm layers, four walls, 100% infill, 220°C nozzle, 50°C bed, no supports or brim. Inspect the revised shapes in your slicer before printing. Adjust temperatures for your filament; inspect grille paths and overhangs.

Assemble

With the base off the tracer, lower the face's three lugs into the entry slots. Viewed from the front, turn it 30° clockwise to the stops, then screw the cap onto the tracer by hand. Keep the 12.5 mm center passage clear.

Turn the face counterclockwise to remove it. Hold the base ring when unscrewing the whole cap, or the face may release first. No screws or glue are needed.

There is no detent. The original clear insert and O-ring aren't used. Previous testing covered my unit; long-term wear and impact protection aren't established.

Sources and credits

OpenSCAD files and a remix guide are included. Keep their folders together. The base and Rounded Crest need BOSL2; the other faces use the included library.

I measured the original cap and tested the prints; Codex and Claude helped with the CAD. Master × Silo photos informed Rounded Crest's styling. This is an unofficial accessory. Gallery images are CAD renders with a stand-in tracer body.

CC BY-SA 4.0: sales and remixes allowed under its terms. Credit Gabriel Almeida and link to the original model, note changes and share adaptations under the same license.

Tagi