1 / 4
Kit Card Monster Truck - Snap-Fit Toy, Rolling Wheels, No Supports — zdjęcie 1
1 / 4

Kit Card Monster Truck - Snap-Fit Toy, Rolling Wheels, No Supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

One flat print, snap out 15 parts and build a monster truck with big rolling wheels. No glue, no supports.

Ocena
0 / 5
Polubienia
2
Pobrania
7
Wydruki
0
Wyświetlenia
27
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — NoDerivatives

A whole monster truck on one flat card. Print it in one go, snap the 15 parts off the frame and slot them together into a chunky 4x4 pickup with huge treaded tires that really roll. No glue, no supports, no screws.

Why it's fun: it prints flat in under an hour and a half, the snap-out moment is satisfying, and the finished truck is about 76 mm long and 46 mm tall, sitting high on 28 mm tires just like a real monster truck. It makes a great party favour, desk toy or quick gift for kids who love trucks.

Parts on the card (15): 2 side panels (truck body with cab window and suspension legs), 3 cross plates (front bumper, middle brace, rear bumper), 2 square axles, 8 tire discs (two per wheel for a fat tire).

Card size: 166 x 126 x 2.5 mm, so it fits beds of 180 x 180 mm and up.

Assembly

Step 1: Snap every part off the card. Twist the gates rather than pulling, then trim any leftover nubs with a knife or flush cutters.

Step 2: Stand the two side panels up, cab windows facing out. Slide the three cross plates up into the slots under the panels so their top notches lock onto the panels (bumper plates at the front and back, the short plate in the middle). The parts interlock like an egg crate.

Step 3: Press one tire disc onto each end of both axles, then a second disc beside it, so each wheel is two discs thick. The square holes key the tires to the axle.

Step 4: Snap each axle up into the round U-slots at the bottom of the side panels. The narrow neck clicks the axle in and lets it spin freely.

Step 5: Roll it across the table. Done.

Print settings: PLA (PETG also works), 0.2 mm layer height, 2 to 3 walls, 15 to 20 % infill, no supports, brim optional. Print time is roughly 1 h 15 min on a modern printer. First-layer squish affects the fit: if the axles won't click in, sand the neck of the U-slot slightly; if the tires are loose, a drop of glue fixes them.

Renders are shown in colour to make the parts easy to tell apart. The card prints in one colour, or use a filament swap or paint for a truck like the pictures.

If you print one, please post a Make with a photo. I'd love to see your trucks, and it helps other people find the model!

Tagi