1 / 3
Swirl & Rings Shelf Bracket – Strong, Support-Free, Screw-Ready — zdjęcie 1
1 / 3

Swirl & Rings Shelf Bracket – Strong, Support-Free, Screw-Ready

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Decorative shelf bracket with rings & spiral scrolls. Prints flat, no supports. 15 mm thick, countersunk for 4 mm screws

Ocena
0 / 5
Polubienia
7
Pobrania
26
Wydruki
1
Wyświetlenia
75
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution

A decorative yet sturdy shelf bracket with a clean geometric look: interlocking rings, rolling spiral scrolls and a smooth curved arch. Looks great printed in matte black, wood-fill or metallic silk filament – and it holds a real shelf, not just decor.

💪 Designed for real use

  • 15 mm thick body with a 12 mm curved arch brace – the arch carries the load, the ring pattern ties wall, arm and arch together for extra stiffness.

  • Reinforced inner corner (R20 gusset) where most brackets break.

  • Countersunk holes for standard 4 mm wood screws (Ø4.5 mm, Ø9 mm 90° countersink) – screw heads sit flush.

  • 2 wall holes (top tab + bottom tail) with free screwdriver access.

  • 1 hole in the shelf arm to screw the shelf from below so it can't slide or tip.

🖨 Printing

  • Lay it flat – no supports needed. The bottom is completely flat.

  • Size: 218 × 225 × 15 mm – fits printers with a 220 × 220 mm bed or larger.

  • Material: PLA / PETG for decor and books, PETG / ASA / Tough PLA for heavier loads.

  • Infill: 25–40 % (Gyroid recommended).

  • Walls: 4–5 perimeters.

  • Layer height: 0.2 mm.

🔩 Mounting

Use 4 mm countersunk wood screws (e.g. 4×30 or 4×40 mm) with wall plugs suited to your wall. Fit the top screw before placing the shelf. Shelf depth up to about 22 cm.

Print two, mount them and enjoy! A make or a photo of your shelf is always appreciated. 🙂

Tagi