Shelf Wedge Support – Fix Shelves That Are Too Short (5 mm & 6 mm Pin Holes) – GarsideWorks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wedge supports for 5 mm or 6 mm shelf-pin holes: give a too-short shelf a 15, 20 or 25 mm resting surface.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 2
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
My wife bought new shelves that turned out too short for the cabinet, so I designed these in Inventor and printed them.
What's tested: the 20 mm wedge with the 6 mm-hole pin (Ø5.9 mm), resin-printed in ABS-like resin on an Anycubic Photon M7, is in daily use in my cabinet. The 15 mm and 25 mm sizes, the 5 mm-hole pin and all FDM prints are untested.
Right-angle wedge with a 10 mm pin with a chamfered tip
Pin Ø5.9 mm for 6 mm holes; Ø4.9 mm for 5 mm holes. Fits 5 mm and 6 mm holes only (not 1/4" holes)
Wedge sizes: 15 mm (15×15 mm top), 20 mm (20×20 mm top, the tested original) and 25 mm (25×25 mm top)
Files: STL, 3MF, STEP
Print settings
Resin (the proven setup): tilt 30–45°, supports on the angled underside only (never on the pin or top face), normal profile, wash, light cure only.
FDM (suggested, untested): print on its triangular side, no supports, 4 walls, 40%+ infill, PETG.
Fit: measure your hole first. If the pin is tight in a 6 mm hole, sand it lightly. Do not use the 4.9 mm pin in a 6 mm hole, because it will wobble.
Notes: No load rating. Not for glass shelves or heavy loads, because the shelf levers on a single pin.