49mm Lens Hood with threads-Wide Angle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/lakqtHH3Esh
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 114
- Wydruki
- 0
- Wyświetlenia
- 598
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/lakqtHH3Esh
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
Yes
Supports:
No
Resolution:
.16
Infill:
20
Filament: eSun PETG Black
Notes:
This is a lens hood with 49mm threads. I am using it for a Vivitar 28mm f2.8 wide angle on a Pentax K1000. Print the Lens Hood with the Threads up, so there is no distortion if you use a brim for stabilization. I used a Brim. I printed it in .16 but it will also work at .20 I used eSun PETG at 230-240C and a 70C bed temp. This eSun PETG will print good for me at low as 229C on an Creality Ender 3 Pro. I printed it at a speed of 30, and retraction of 4.0 and 45. This is a 20% infill.
If you do design your own lens threads, use 4 to 5 threads at 0.75 pitch and a thread angle of 0.60
If you are printing it and it gets “stringy”, reduce the temperature of the nozzle.
Good Luck :)
Greg
Category: 3D Printing