Kit Card Excavator - Snap-Fit Toy, Poseable Arm, No Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One flat print: snap out 13 parts and build a toy digger with a moving boom, arm and bucket. No glue, no supports.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 39
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — NoDerivatives
A tracked excavator you print as one flat card. Snap the 13 parts off the sprue, slot them together and you have a little digger with a boom, arm and bucket that all pivot and hold their pose. No glue, no supports, no extra hardware.
Why it's fun: the whole kit prints in under two hours, it's a satisfying 5 minute build, and the finished digger actually scoops. Great as a desk toy, a party favour for kids who love construction machines, or a quick test print to show off your printer.
Parts on the card: 2 tracks, 2 track cross beams, 2 house side plates (with cab windows), 1 counterweight, 1 boom, 1 arm (stick), 1 bucket, 1 long axle and 2 short axles.
Card size: 126 x 88 mm, 2.5 mm thick. Built model is roughly 85 mm long, 32 mm wide and 50 mm tall with the boom raised.
Step 1: Snap or clip every part off the card and trim any leftover gate nubs flat with a hobby knife or flush cutters.
Step 2: Build the undercarriage. Stand the two tracks up with their slots facing upward and push the two cross beams down onto them so the slots interlock like an egg crate.
Step 3: Slide the two house side plates down into the top slots of the cross beams, cab windows facing forward.
Step 4: Drop the counterweight into the slots at the back of the house plates.
Step 5: Put the round hole of the boom between the house plates and push the long axle through both house plates and the boom. The square holes grip the axle and the boom swings on it.
Step 6: Hang the arm on the end of the boom with a short axle (square hole in the boom, round hole in the arm).
Step 7: Attach the bucket to the bottom of the arm with the last short axle (square hole in the bucket). Pose it and start digging!
Print settings: PLA, 0.2 mm layer height, 2 to 3 walls, 15% infill, no supports. A brim is optional but helps on the thin gates. Print flat exactly as it comes in the file. It takes about 1.5 to 2 hours on a typical printer.
Fit tips: the axles are 2.5 mm square and the square holes are 2.6 mm for a press fit. If the round pivot holes are too tight on your printer, twist a 3.7 mm drill bit or a hobby knife through them; if a joint is floppy, a tiny dab of glue stick on the axle firms it up.
If you print one, please post a Make with a photo! I love seeing everyone's colour combos, and it helps other people find the kit. Check out my other kit cards too.
