Under-desk cable clips: open hooks and sliding-lid hooks (7 sizes, 1 screw)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Under-desk cable hooks: open or sliding lid, Ø16–Ø50 mm, one screw, prints on its side without supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 13
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Small hooks that screw to the underside of a desk and hold a bundle of cables. Each part is fixed with ONE countersunk screw that sits in the floor of the hook; the screwdriver goes through a Ø9.6 mm access hole in the top of the hook.
Two families: open hooks (cables go in through a rounded slot) and locking hooks, where a sliding lid clicks in from the end and closes the slot. The basic series come in seven sizes, Ø16 / 20 / 24 / 28 / 34 / 40 / 50 mm, plus wide, three-in-one, stem, diagonal, angled, flat oval, double, wall-brace, saddle, split-lid, pull-tab, double-detent and strap-slot versions.
How to insert cables (lid versions): 1. Pull the lid out by its flange. 2. Lay the cables in from the side, or thread them through the ring from the end. 3. Slide the lid back in until it clicks. With the rear-stop version the lid stops against the stop at the far end.
Printing: print on its side with the ring axis vertical (the STL files are already rotated). PETG, ASA or ABS (PLA creeps under constant load), 0.2 mm layers, 4 walls, 40% gyroid. No supports needed: the only overhang is the ceiling of the screwdriver access hole, a short bridge. Print profiles with and without supports are in the catalog ZIP. Example: the Ø28 hook is about 8 g and about 21 minutes on a Bambu X1C.
Files: print-ready STL (65 files), STEP (editable in Fusion and other CAD), one Blender file with all parts, a PDF catalog in English and Czech with the dimensions of every size, Bambu Studio / Orca print profiles and the parametric CadQuery source.
Screw (not included): countersunk wood screw Ø4 x 20 mm, one per part.
Notice: verified in design and with a slicer (watertight meshes, screwdriver access, overhangs, lid collisions) but not test-printed yet. Please check the detent strength and the 0.35 mm lid clearance on a printed sample first.
CZ: Kabelove uchyty pod stul. Male haky, ktere se prisroubuji pod desku stolu a drzi svazek kabelu, kazdy jednim zapustnym sroubem v dne haku. Otevrene haky a haky se zasouvacim vickem. Tisk na bok bez podpor, PETG, vrstva 0,2 mm, 4 perimetry, vypln 40 % gyroid. Katalog s rozmery a popisem v cestine a anglictine je v PDF. Dily jsou overene v navrhu a slicerem, ale zatim nevytistene.