1 / 9
Rainfall Cube Lamp, Swap the Glow, No Supports — zdjęcie 1
1 / 9

Rainfall Cube Lamp, Swap the Glow, No Supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cube lamp with rain cut through every side and bursting open on top. Swap the Diffuser to change the glow. No supports.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
35
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Living Room
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Pluvia

Rain runs down every side of this cube and bursts open on the top. The streaks are cut clean through the walls and run over the corners, so with the light on, only the rain lights up.

For a desk, a shelf or a bedside table. Runs on a standard 60 mm USB LED light kit and twists and clips together without glue or screws.

Swap the glow

The colour comes from the Diffuser, a thin insert printed in Spiral vase. Print a few in different colours: pull the Sleeve gently off the Lock ring, swap the Diffuser and clip the Sleeve back on.

Prefer one Diffuser for everything? Print it in white and use an RGB LED light: the cube then glows in any colour your light can make.

Other colour combinations

A few more ideas for the Sleeve and the glow, rendered from the model files.

Two sizes

You will need

One 60 mm LED light kit, USB, 5 V. Nothing else.

Printing

Each file has two plates:

  • Base and Sleeve: the Base, the Lock ring and the Sleeve.

  • Diffuser components: the Diffuser and the Diffuser cap, already set to Spiral vase on the plate.

The settings are already in the files. Printing from your own profile? Use these:

  • Wall generator: Arachne, for every part.

  • Diffuser and Diffuser cap: Spiral vase.

  • Sleeve: 3 walls, wall order outer/inner.

  • Base and Lock ring: concentric top surface, 7 % gyroid infill.

  • Supports: off.

Print the Diffuser in a light or translucent filament, so the glow comes through.

Assembly

  1. Drop the LED light into the Base and lead the cable out through the slot.

  2. Twist the Lock ring onto the Base until it stops.

  3. Lay the Diffuser cap on the Lock ring and push the Diffuser onto it.

  4. Clip the Sleeve onto the Lock ring, over the edge that runs around it.

Parts

Base, Lock ring, Sleeve, Diffuser and Diffuser cap.

Tagi