Adjustable iPhone Duo Holder for Herringbone Edge Phone Stand (Folded + Unfolded)

This is a modified Phone Holder Gear and a new Click-Stop Sliding Carriage designed to adapt the Phone Stand Herringbone Edge by Pork3D.com for the foldable iPhone Duo in both folded and unfolded modes, with or without a case.

Because the original stand uses the Standard Digital File License, only the modified holder gear and the new sliding carriage are included here. Download the remaining 4 unchanged parts (Base L, Base R, Knob, and Middle Gear) directly from the original model: https://www.printables.com/model/1601583-phone-stand-herringbone-edge-by-pork3dcom

How It Works (2-Step + Click-Stop Slider)

• Lower Inner Step (Unfolded Mode, 5.2 mm bare up to 9.5 mm cased): Drops the phone 3.5 mm lower into the cradle with its own 16 mm tall front retaining lip so the thin unfolded screen sits deep and cannot tip forward.
• Upper Outer Step + Click-Stop Sliding Carriage (Folded Mode, 11.3 mm bare up to 17.0 mm rugged case): A captive dovetail slider moves along the upper shelf and clicks into 0.75 mm detents across a 12.0 mm travel range, letting you snug the front lip against any folded thickness or case.
• Widened Dual-Cradle Arms (110 mm outer span): Supports the 164.6 mm unfolded width without blocking the bottom USB-C port.

Print Settings

• Material: PLA or PETG
• Layer Height: 0.20 mm
• Walls / Perimeters: 3
• Infill: 15% Gyroid
• Supports: Print the slider flat with no supports. On the Phone Holder Gear, enable manual snug supports only under the two short horizontal dovetail rail roof sections (already pre-painted in the included .3mf project); do not put supports on the herringbone gear teeth.