1 / 4
Rii Mini keyboard wall holder – better fit + keyhole mount (remix) — zdjęcie 1
1 / 4

Rii Mini keyboard wall holder – better fit + keyhole mount (remix)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of micsafdas' Rii Mini holder: measured pocket, tapered front plate, keyhole slots for wall mounting.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
4
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

This is a remix of the Rii Mini keyboard holder by micsafdas (https://www.printables.com/model/977295). I liked the organic lines of the original, but my Rii mini keyboard (155.3 mm wide, 14.5 mm thick at the bottom edge and 16.2 mm at the top) had to be forced into the pocket, and there was no way to screw the holder to a wall. So I kept the shape and redesigned the inside and the back.

What changed

  • Pocket measured on the actual keyboard: 155.9 mm wide, 15.1 mm deep at the floor and 16.8 mm at the top (0.3 mm clearance per side). The front plate leans slightly forward at the top so it follows the wedge of the keyboard.

  • 1.5 mm lead-in chamfers at the top of the pocket, so the keyboard drops in without aiming.

  • Two flat 14 mm strips at the back with keyhole slots (9 mm entry, 4.8 mm slot, 141.9 mm centre to centre). Put two 4 mm pan-head screws in the wall, leave the heads about 3 mm proud, and hang the holder on them. The slots sit behind the front plate, so a screwdriver cannot reach them from the front; the keyhole solves that. The flat back also works with double-sided tape.

  • Oval floor corners, 2 mm foot chamfer and rounded edges like the original.

  • Outer size 160.9 x 24.3 x 76 mm.

Printing

Print it standing on its foot, front plate facing you. No supports needed; the 9 mm bridges in the keyhole slots print fine. I printed it in PLA on a Prusa CORE One at 0.25 mm layers without a brim. PETG works as well.

Files

  • Houder Rii mini-toetsenbord v5.stl: the holder

  • Houder Rii mini-toetsenbord v5.step and .FCStd: for your own edits

  • houder_rii.py: the FreeCAD script that generates the model. All dimensions are parameters at the top (keyboard width, thickness top and bottom, clearances, slot sizes), so you can regenerate it for another keyboard with freecadcmd.

Original model by micsafdas, licensed CC BY-NC 4.0. This remix carries the same license.

Tagi