Snapmount for Ikea Hallbar frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter / mount for the Ikea Hallbar frame so that the whole frame can be snapped on and off the rails / slides
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 4
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- GNU General Public License v3.0
The Hallbar frame is quite cumbersome to remove as you either have to unscrew the rails completely or unscrew the rails from the frame from the underside.
I have the frame mounted under the sink, so it also gets in the way when I have to work on the sink or the piping behind it.
Mounting
Unscrew the rails from the frame
Remove the little flat connector plate from the rails (the ones that hold down the rail with the screw you just unscrewed)
Use the original screw to screw in the snap mounts instead
Slide the rails beneath the plastic hooks in the back of the frame like normal and then just snap them into place
Be careful on the initial snap-off as it may require quite a bit of additional strength! Subsequent snaps will be easier.
Usage
Remove bins from frame
Pull the front of the frame up to unsnap
Lift the frame back a bit to unhook and then lift off
To snap back on simply hook the frame back into the plastic hooks in the back and snap the frame back down in front, it should give a satisfying snap
Print instruction
Use PETG or similar (PLA might be too brittle)
Print sideways with either of the flat side of the spring laying on the bed for most strength
At least 3 perimeters with 0.6mm nozzle, 4 perimeters with 0.4mm (the spring should be completely perimeters)
Supports shouldn't be required
Layer height doesn't matter much, I used 0.2mm
One for each side, no need to mirror