Peristaltic Pump Base for V2 NEMA 17 pump by Maximilian Puschmann
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stable base for V2 NEMA 17 Peristaltic pump made by Maximilian Puschmann. The base is my own design.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
A stable base to hold the V2 NEMA 17 Peristaltic Pump originally designed by Maximilian Puschmann.
This base accepts the NEMA 17 pump assembly and holds it flat during use. I designed this because the pump normally sits on top of the motor which is not the most stable setup. It also includes a channel for the power wires.
This base is a relatively loose fit. The pump will simply rest inside the cutout and is easy to lift out. If you want a snug fit around the pump, I suggest printing at 98% scale. Or use some thin rubber pads around the edges of the pump receptacle cutout to snug things up.
The other modification that I made was adding rubber feet to the bottom so it doesn't slide around on the table. I just used some generic 10mm cabinet bumpers for mine. Pretty much any rubber bumper pad will work.