Tellaprompter: ESP32 Teleprompter Monitor Frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A frame that hangs a touchscreen teleprompter on top of your monitor, from Louise de Sadeleer and Sam Beek's build.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 6
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
The original Tellaprompter build running its own firmware; the guide's starter sketch is portrait.
A frame that hangs a small touchscreen teleprompter on the top edge of your monitor, just above the webcam, so you can read a script while looking at the camera. Louise de Sadeleer and Sam Beek built the original Tellaprompter; the guide links their build video.
The frame was made for the ESP32-P4 touchscreen used in that original build. It is 132 × 80 × 1 mm with a 117 × 65 mm window. The guide's starter uses a 3.2-inch ILI9341 touchscreen on an ESP32 DevKit v1 instead, so measure your display against the window before you print.
The starter firmware scrolls a script stored in the sketch. A push button pauses and resumes it; tap the left half of the screen to slow down and the right half to speed up, across 8 speeds. It starts paused: press the button to begin. To change the script, edit the text in the sketch and deploy again.
Parts (guide starter)
ESP32 DevKit v1
3.2-inch ILI9341 TFT touchscreen, 240 × 320, with XPT2046 touch
Push button
Jumper wires
Printing
One STL with three parts: the frame (132 × 80 × 1 mm) and two clips (29.9 × 37.3 × 6.9 mm). The clips hook over a monitor edge about 24 mm thick; the original hangs on an Apple Studio Display. OrcaSlicer 2.4.2 estimates about 16 min for all three on a Bambu Lab P1S (0.4 mm nozzle, 0.20 mm Standard, Bambu PLA Basic, auto-orient, no supports, 20% infill), and it slices cleanly.
Assembly
With everything unpowered, wire the touchscreen to the ESP32 as in the guide's pin table: display and touch share the SPI bus (MOSI GPIO23, MISO GPIO19, SCK GPIO18).
Wire the button between GPIO21 and GND.
Open the Tellaprompter starter in Schematik and deploy it to the ESP32 from Chrome or Edge.
Hang the frame on the top edge of your monitor with the two clips.
Full guide with wiring and firmware: https://www.schematik.io/projects/build-the-tellaprompter-esp32-touchscreen
Firmware and wiring guide generated with Schematik, our AI hardware tool; the enclosure was modelled by hand.