ESP32 Project Box with Screw Lid and USB Cutouts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact box with screw-down lid for an ESP32 dev board, with standoffs and USB-C and micro-USB cutouts.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 2
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
A small enclosure for an ESP32 development board. Inside size is about 68 x 42 x 22 mm (outside 72.4 x 45.9 x 24 mm, lid 5 mm). The PCB sits on four standoffs, the lid is fixed with M3 screws, and there are cutouts for USB-C (front) and micro-USB (back). Files: box body STL, lid STL, and both together as STL and 3MF (laid out for printing). PRINT SETTINGS: layer height 0.2 mm, 3 perimeters, 15% infill. No supports: the body prints open side up, the lid prints flat. Screws: M3, self-tapping into the standoffs. Check your board's hole spacing before printing, as ESP32 boards vary. Material: PLA or PETG. Both parts were checked watertight (single shell each, no non-manifold edges). Made with Project Box Maker for Blender: https://superhivemarket.com/products/project-box-maker