ESP32 Project Box with Screw Lid and USB Cutouts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Compact box with screw-down lid for an ESP32 dev board, with standoffs and USB-C and micro-USB cutouts.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 2
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
A small enclosure for an ESP32 development board. Inside size is about 68 x 42 x 22 mm (outside 72.4 x 45.9 x 24 mm, lid 5 mm). The PCB sits on four standoffs, the lid is fixed with M3 screws, and there are cutouts for USB-C (front) and micro-USB (back). Files: box body STL, lid STL, and both together as STL and 3MF (laid out for printing). PRINT SETTINGS: layer height 0.2 mm, 3 perimeters, 15% infill. No supports: the body prints open side up, the lid prints flat. Screws: M3, self-tapping into the standoffs. Check your board's hole spacing before printing, as ESP32 boards vary. Material: PLA or PETG. Both parts were checked watertight (single shell each, no non-manifold edges). Made with Project Box Maker for Blender: https://superhivemarket.com/products/project-box-maker