1 / 16
SpotMicroESP32 (using 623ZZ bearings)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Software:https://github.com/projunk/SpotMicro Following minor changes were made compared to the original. Use of M3…
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 478
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (27)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (17)Powiązane
Software: https://github.com/projunk/SpotMicro
Following minor changes were made compared to the original.
- Use of M3 screws/nuts only (except servo horns)
- Use of 623ZZ bearings (8x)
- Fixed nuthole size in Wrist_Counterpart (nuts were slipping due to too large size of nuthole)
- Fixed hole sizes for all tiny servo horn screws (M1.7*6)
Changes 21 September 2020:
- added Circuitboard_Mount_10A.stl (2 x Buckconverter 3A, 4x Buckconverter 10A, 1x PCA9685, 1 x PCB with esp32 devboard)
- added Front_Cover_Optimized.stl. This version is 15 mm longer than the original, so that it has more space to hold the electronics)
- added Cameramount.stl (camera part replaced by pcb holder for the electronics)
Changes 26 September 2020:
- added alternative Circuitboard_Mount_20A.stl (2 x Buckconverter 3A, 2x Buckconverter 20A, 1x PCA9685, 1 x PCB with esp32 devboard)
- added alternative version Chassis_Side.stl. The vertical position of the electronics plate can be controlled by parameter "offsetElectronicsPlateY".
Changes 27 September 2020:
- added extra cable hole to "Inner_Shoulder.stl"
- moved connection point between bottom shells to avoid collision with 20A buckconverters (Bottom_Cover_Split_Front.stl, Bottom_Cover_Split_Rear.stl)
Category: Model Robots