1 / 16
SpotMicroESP32 (using 623ZZ bearings)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Software:https://github.com/projunk/SpotMicro Following minor changes were made compared to the original. Use of M3…
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 33
- Makes
- 0
- Views
- 478
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Action Figures & Statues
- License
- Creative Commons — Attribution
Software: https://github.com/projunk/SpotMicro
Following minor changes were made compared to the original.
- Use of M3 screws/nuts only (except servo horns)
- Use of 623ZZ bearings (8x)
- Fixed nuthole size in Wrist_Counterpart (nuts were slipping due to too large size of nuthole)
- Fixed hole sizes for all tiny servo horn screws (M1.7*6)
Changes 21 September 2020:
- added Circuitboard_Mount_10A.stl (2 x Buckconverter 3A, 4x Buckconverter 10A, 1x PCA9685, 1 x PCB with esp32 devboard)
- added Front_Cover_Optimized.stl. This version is 15 mm longer than the original, so that it has more space to hold the electronics)
- added Cameramount.stl (camera part replaced by pcb holder for the electronics)
Changes 26 September 2020:
- added alternative Circuitboard_Mount_20A.stl (2 x Buckconverter 3A, 2x Buckconverter 20A, 1x PCA9685, 1 x PCB with esp32 devboard)
- added alternative version Chassis_Side.stl. The vertical position of the electronics plate can be controlled by parameter "offsetElectronicsPlateY".
Changes 27 September 2020:
- added extra cable hole to "Inner_Shoulder.stl"
- moved connection point between bottom shells to avoid collision with 20A buckconverters (Bottom_Cover_Split_Front.stl, Bottom_Cover_Split_Rear.stl)
Category: Model Robots