1 / 4
OpenWrt One Router 1U Holder for 10-inch Mini Rack — zdjęcie 1
1 / 4

OpenWrt One Router 1U Holder for 10-inch Mini Rack

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A 1U tray for 10" mini racks that holds the OpenWrt One router, with an open front for the ports.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
24
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Rack mount for the OpenWrt One router in a 10" (254 mm) mini rack. It takes exactly 1U (44.45 mm) and screws into standard 10" rails with M6 screws.

The router sits on a tray with its ports facing out through the front panel, so you can reach all the cables from the front of the rack. Curved side gussets keep the tray stiff, and slotted vents in the side walls let air through. A separate rear plate holds the router in place from behind.

Features

  • Full 10" width (254 mm) and 1U height (44.45 mm)

  • Standard 10" rack hole pattern (rack ears with slotted 6.5 mm holes)

  • Front opening that leaves the router's ports reachable

  • Vented side walls with chamfered slots for airflow

  • Large filleted gussets: stiff tray, no sagging

  • Separate rear retainer plate, so the router can't slide out the back

  • About 110 mm deep, fits shallow racks

  • Prints without supports (see print settings)

Hardware needed

  • 4× M6 rack screws + cage/clip nuts (or whatever your rack uses)

  • 2x M3 screws + 2x M3x4x5 heat-set insert

Tagi