1 / 4
OpenWrt One Router 1U Holder for 10-inch Mini Rack — image 1
1 / 4

OpenWrt One Router 1U Holder for 10-inch Mini Rack

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A 1U tray for 10" mini racks that holds the OpenWrt One router, with an open front for the ports.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
24
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Rack mount for the OpenWrt One router in a 10" (254 mm) mini rack. It takes exactly 1U (44.45 mm) and screws into standard 10" rails with M6 screws.

The router sits on a tray with its ports facing out through the front panel, so you can reach all the cables from the front of the rack. Curved side gussets keep the tray stiff, and slotted vents in the side walls let air through. A separate rear plate holds the router in place from behind.

Features

  • Full 10" width (254 mm) and 1U height (44.45 mm)

  • Standard 10" rack hole pattern (rack ears with slotted 6.5 mm holes)

  • Front opening that leaves the router's ports reachable

  • Vented side walls with chamfered slots for airflow

  • Large filleted gussets: stiff tray, no sagging

  • Separate rear retainer plate, so the router can't slide out the back

  • About 110 mm deep, fits shallow racks

  • Prints without supports (see print settings)

Hardware needed

  • 4× M6 rack screws + cage/clip nuts (or whatever your rack uses)

  • 2x M3 screws + 2x M3x4x5 heat-set insert

Tags