Kit Card Forklift - Snap-Fit Toy, Lifting Forks & Pallet, No Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One flat print: snap out the parts and build a forklift with sliding forks, wheels and a pallet. No glue, no supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 25
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — NoDerivatives
A complete forklift toy on one flat kit card. Print the card, snap the parts out of the frame and build a little warehouse forklift with forks that really slide up and down the mast, four rolling wheels, an overhead guard, a driver's seat and its own pallet to pick up. Everything slots together - no glue, no screws, no supports.
Why it's fun: it prints fast and flat, the snap-out step feels like building a real model kit, and once it's together you can roll it around the desk, slide the forks under the pallet and lift it off the ground.
Parts on the card (22 pieces): 2 body side plates, 2 front bulkheads, rear guard frame with counterweight, front guard frame with dashboard, roof, seat, 2 mast rails, fork carriage, 2 forks, 4 wheels, 2 square axles, pallet deck and 2 pallet runners.
Card size: 137 x 121 x 2.5 mm. Assembled forklift: about 72 mm long, 32 mm wide and 50 mm tall.
Assembly
Step 1: Twist each part out of the card. The gates are only 1.0 mm thick, so they break off cleanly. Trim any nubs with a hobby knife or a nail file.
Step 2: Stand the two yellow side plates up (slots facing up) and push the rear guard frame, the seat and the front guard frame down into the matching slots. These are cross-halving joints, so each pair locks into the other.
Step 3: Hold the two grey mast rails between the front ends of the side plates, feet pointing back and slots facing up. Push the two small bulkheads down over the side plates and the rail feet at the same time. This locks the mast to the body.
Step 4: Slide the black fork carriage sideways through the long windows in both mast rails, then push the two forks down onto the carriage slots. The forks keep the carriage centred, and the carriage now slides up and down the mast.
Step 5: Clip the square axles up into the round slots under the body, then press a wheel onto each end. The square holes grip the axle so the wheels and axle roll together.
Step 6: Drop the roof onto the four tabs on top of the guard posts.
Step 7: Build the pallet: press the deck down onto the tabs of the two runners. Now slide the forks under it and lift!
Print settings
PLA, 0.2 mm layers, 3 perimeters, 15-20% infill, no supports. A brim is optional (helps if your bed adhesion is weak). Print time is roughly 1.5 to 2 hours depending on your printer. Slots are 2.65 mm for 2.5 mm parts; if your printer over-extrudes and a joint is too tight, a quick pass with a file or sandpaper fixes it. The fork carriage is meant to be a snug slide so the forks stay where you leave them.
If you print one, please post a Make with a photo - I'd love to see your forklift, and it helps other people find the model. Check my profile for more kit cards: trucks, planes, a tank, a locomotive and more.
