1 / 4
Kit Card Airliner - Snap-Fit Jet Plane with Stand, No Supports — zdjęcie 1
1 / 4

Kit Card Airliner - Snap-Fit Jet Plane with Stand, No Supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

One flat print: snap out 7 parts and build a twin-engine passenger jet on a display stand. No glue, no supports.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
4
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — NoDerivatives

A twin-engine passenger jet that prints as one flat kit card. Snap the 7 parts off the sprue, slot them together and your airliner is ready for take-off on its own display stand. No glue, no supports, no extra hardware.

Why it's fun: it prints in under an hour, it's a great little build for kids and aviation fans, and the finished plane looks great on a desk or shelf. Print the card in one colour, or print a couple of cards in different colours and mix the parts for your own airline livery.

Parts on the card: fuselage with tail fin, main wing, horizontal tail (stabilizer), two engines, stand post and stand base.

Card size: about 93 x 106 mm, 2.5 mm thick. Assembled plane: about 84 mm long with a 79 mm wingspan, roughly 62 mm tall on its stand.

Assembly

Step 1: Snap every part off the card. Twist gently at the thin gates and clean up any leftover nub with a craft knife or a fingernail.

Step 2: Lay the main wing flat. Press the fuselage down onto it so the two tabs under the belly drop into the two square holes in the middle of the wing.

Step 3: Push the horizontal tail onto the tab under the tail cone in the same way.

Step 4: Slide each engine onto the wing from the front. The slot in the wing's leading edge guides the pylon, and the hook clips over the top of the wing.

Step 5: Push the stand post into the slot in the base. Set the plane on top so the front belly tab sits in the notch at the top of the post.

Print settings

PLA, 0.2 mm layers, 0.4 mm nozzle, 15-20% infill (the parts are thin, so they print almost solid anyway). No supports. Brim optional; it can help the thin gates stick on a smooth bed. Print time is roughly 45-60 minutes depending on your printer.

If a joint is too tight, sand the tab lightly. If it's loose, a tiny bit of tape or a drop of glue fixes it, but on most printers it snaps together snugly.

This is one of a series of kit cards. Check my profile for the others: race cars, trucks, a helicopter, a fighter jet, a biplane and more.

If you print one, please post a Make with a photo. I'd love to see your airline colours!

Tagi