adjustable endstop housing left side
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
adjustable endstop housing left side This adjustable endstop housing was designed for a DIY laser cutter project. The…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 289
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
adjustable endstop housing left side
This adjustable endstop housing was designed for a DIY laser cutter project.
The end stop is fixed with two M3 with 15mm screws and nuts in the housing.
The case itself is attached to the item profile with two M4 screws and the matching M4 T-Nuts. With the upper screw, the endstop can now be precisely adjusted
(+) adjustable with the upper M4 screw
(+) very precise and form-fitting
(+) high stability if the infill is increased accordingly
(-) only for mechanical end stops like Makerbot / ReRap
The endstop housing was attached here with two M4 T-Nuts and can be downloaded here: https://www.thingiverse.com/thing:2770009
check out the matching counterpart so you can put a stop on both sides. ;-) https://www.thingiverse.com/thing:2849331
Print Settings
Printer Brand:
MakerBot
Printer:
MakerBot Replicator 2X
Rafts:
No
Supports:
Yes
Resolution:
0,2mm
Infill:
10%
Notes:
With the mentioned settings, the endstop fits very precisely, depending on the endstop model the holes have to be slightly reworked.
Category: Parts