1 / 4
ALNO cooker hood replacement rail
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
ALNO cooker hood replacement rail
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 165
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
I have an old ALNO kitchen. The panel of the cooker falls down because the rails are completely disconnected from it. So I created a 3D model in order to replace them. The pannel was originally held by plastic rivets end I think that my model, printed with PLA and settled with screws, is definitely more reliable.
I hope the design might be useful to someone else.
Notes
- The model is designed to be printed with layer height of 0.3 mm.
- Set perimeter at 100 (is the same as infill 100% but stronger for lines direction).
- Each rail is divided in two pieces to be printed in a common (20x20cm base) printer and the alignment (while gluing) is obtained with a piece of 1.75mm filament in the little holes.
- 8 bolts and nuts are needed. I used m4x10 (they were a little bit too long, I had to cut them later).