1 / 4
ALNO cooker hood replacement rail
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
ALNO cooker hood replacement rail
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 164
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Public Domain
I have an old ALNO kitchen. The panel of the cooker falls down because the rails are completely disconnected from it. So I created a 3D model in order to replace them. The pannel was originally held by plastic rivets end I think that my model, printed with PLA and settled with screws, is definitely more reliable.
I hope the design might be useful to someone else.
Notes
- The model is designed to be printed with layer height of 0.3 mm.
- Set perimeter at 100 (is the same as infill 100% but stronger for lines direction).
- Each rail is divided in two pieces to be printed in a common (20x20cm base) printer and the alignment (while gluing) is obtained with a piece of 1.75mm filament in the little holes.
- 8 bolts and nuts are needed. I used m4x10 (they were a little bit too long, I had to cut them later).