1 / 3
Wera Allen Key Hex Key Set Pegboard Holder (9 Piece & 13 Piece Versions) — zdjęcie 1
1 / 3

Wera Allen Key Hex Key Set Pegboard Holder (9 Piece & 13 Piece Versions)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A set of two Wera allen key/hex key set holder adaptors compatible with 1"/25mm pegboard.

Ocena
0 / 5
Polubienia
14
Pobrania
149
Wydruki
0
Wyświetlenia
1713
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A set of two Wera allen key/hex key set holder adaptors compatible with 1"/25mm pegboard. The smaller adaptor works with 9-piece hex key sets and the larger one works with 13-piece hex key sets. 

The pegboard hooks are tailored for my Sealey steel pegboard. They will probably fit other makes, but may need a little fine tuning of the gap between the back of the adaptor and the forward face of the hooks to nip up nice and tight (or loosen off if too tight).

I couldn't find any decent holders for these Wera sets. One was too flimsy and broke in less than a day and another had nothing to hold the sets in place, so they fell off even nudged even a smidge. I made these ones to fill the void: they work well and have been in use in my workshop for six months without issue. 

You may or may not require supports for the upper hooks on the model. On my printers, they don't need supports, but if you don't have bridging dialled in well, you may be some support. You will need supports for the lower pegs if you want the best possible fit on the pegboard. 

I used an existing stl I found online to get the basic dimensions for the small adaptor, but I can no longer find it to link it here. 95% of the design is my own. Please feel free to print and use, but no commercial usage or commercial remixes please: I share my designs for others to benefit from practically, not financially!

Tagi