Supports for shelf with old skateboards
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Supports to build a shelf with old skateboards
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 272
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
Supports to build a shelf out of old skateboards.
No supports needed when printing. Higher density is better, I used 25%.
- Two screws through the board, you can use the skateboard hardware
- Two screws for each leg, but you can get away with only one.
- Floor brush sticks for the legs, but anything similar will do.
Haven't tested how much weight it can handle, but I have been using it for a couple of months with up to 6kg of filament on top of it.
Since the boards are concave they work really well as a filament shelf, they prevent the spool to roll out of the shelf.
It wobbles a bit, but you can probably stop it from wobbling by screwing some sort of cross on the back.
You can probably build one with more than 2 boards, let me know if you try.